LEGRAND Raritan SRC-0100, Руководство пользователя

Страница: 529 / 698

Chapter 8: Using the Command Line Interface
517
Setting the Baud Rates
The following commands set the baud rate (bps) of the serial port
labeled CONSOLE / MODEM on the SRC device. Change the baud rate
before connecting it to the desired device, such as a computer, a
Raritan's P2CIM-SER, or a modem, through the serial port, or there are
communications errors. If you change the baud rate dynamically after
the connection has been made, you must reset the SRC or power cycle
the connected device for proper communications.
Determine the CONSOLE baud rate:
config:# serial consoleBaudRate <baud_rate>
Note: The serial port bit-rate change is required when the SRC works in
conjunction with Raritan's Dominion LX KVM switch. Dominion LX only
supports 19200 bps for communications over the serial interface.
Determine the MODEM baud rate:
config:# serial modemBaudRate <baud_rate>
Variables:

<baud_rate> is one of the baud rate options: 1200, 2400, 4800, 9600,
19200, 38400, 57600, 115200.
Forcing the Device Detection Mode
This command forces the serial port on the SRC to enter a specific device
detection mode.
config:# serial deviceDetectionType <mode>
Variables:

<mode> is one of the detection modes:
automatic, forceConsole,
forceAnalogModem, or forceGsmModem.
Option Description
automatic The SRC automatically detects the type of
the device connected to the serial port.
Select this option unless your SRC cannot
correctly detect the device type.