LEGRAND Raritan PX3-3000 Series, Руководство пользователя

Страница: 718 / 977

Chapter 8: Using the Command Line Interface
697
Multi-Command Syntax
To shorten the configuration time, you can combine various configuration
commands in one command to perform all of them at a time. All
combined commands must belong to the same configuration type, such
as commands prefixed with
network, user modify, sensor externalsensor
and so on.
A multi-command syntax looks like this:
<configuration type> <setting 1> <value 1> <setting 2>
<value 2> <setting 3> <value 3> ...
Example 1 - Combination of ETH1's Activation, Configuration Method and IP
The following multi-command syntax configures IPv4 address,
configuration method and activation status for ETH1's network
connectivity simultaneously.
config:# network ipv4 interface eth1 enabled true configMethod static
address 192.168.84.225/24
Results:

The ETH1 interface is enabled.

ETH1's configuration method is set to static IP address.

ETH1's IPv4 address is set to 192.168.84.225/24.
Example 2 - Combination of Upper Critical and Upper Warning Settings
The following multi-command syntax simultaneously configures Upper
Critical and Upper Warning thresholds for the RMS current of the 2nd
overcurrent protector.
config:# sensor ocp 2 current upperCritical disable upperWarning 15
Results:

The Upper Critical threshold of the 2nd overcurrent protector's RMS
current is disabled.

The Upper Warning threshold of the 2nd overcurrent protector's
RMS current is set to 15A and enabled at the same time.