LEGRAND Raritan PX3-3000 Series, Руководство пользователя, Страница: 54 / 977

Chapter 3: Initial Installation and Configuration
33
DB9 pin signal DB9 pin No. RJ-45 pin No. RJ-45 pin signal
RTS 7 8 CTS
DCD 1 (Not connected)
RI 9 (Not connected)
N/A
Note: The blue Cisco RJ-45 to DB9 adapter cable CANNOT be used for
connecting a modem. See
RJ45-to-DB9 Cable Requirements for
Modem Connections (on page 888).
Bulk Configuration Methods
If you have to set up multiple PX3 devices, you can use one of the
following configuration methods to save your time.
A bulk configuration file downloaded from PX3:

Requirement: All PX3 devices to configure are of the same model
and firmware.

Procedure: First finish configuring one PX3. Then download the bulk
configuration file from it and copy this file to all of the other PX3
devices.
See Bulk Configuration (on page 464).
A TFTP server:

Requirement: DHCP is enabled in your network and a TFTP server is
available.

Procedure: Prepare special configuration files, which must include
fwupdate.cfg, and copy them to the root directory of the TFTP server.
Re-boot all PX3 devices after connecting them to the network.
See
Bulk Configuration or Firmware Upgrade via DHCP/TFTP
(on
page 764).
Curl command:

Requirement: Two files are required -- one is a configuration file in
TXT and the other is a devices list file in CSV. See
config.txt
(on page
756) and
devices.csv
(on page 759).

Procedure: Upload both files to all of PX3 devices one by one, using
the appropriate curl command.
See
Upload via Curl
(on page 790).