LEGRAND Raritan PX3-3000 Series, Руководство пользователя, Страница: 43 / 977

Chapter 3: Initial Installation and Configuration
22
Connecting the PX3 to Your Network
To remotely administer the PX3, you must connect the PX3 to your local
area network (LAN). PX3 can be connected to a wired or wireless
network.
Note: If your PX3 will work as a master device in the bridging mode, you
must make a wired connection. See
Cascading Multiple PX3 Devices
for Sharing Ethernet Connectivity
(on page 34).
Ethernet port of PX3 must be enabled for the described connection to
work properly, which has been enabled per default. See
Wired Network
Settings
(on page 287).
To make a wired connection:
1. Connect a standard network patch cable to either or both Ethernet
ports on the PX3.

The two Ethernet ports must be connected to different subnets.
See
Dual Ethernet Connection
(on page 24).

The "green" Ethernet port labeled "ETH 10/100/1000" supports
up to 1000 Mbps so it is highly recommended for network
connection.
2. Connect the other end of the cable to your LAN.
Below illustrates the ETHERNET ports on PX3 Zero U models. Note that the
port locations on your models may differ.
Warning: Accidentally plugging an RS-232 RJ-45 connector into the
Ethernet port can cause permanent damage(s) to the Ethernet
hardware.
To make a wireless connection:
Do one of the following: