38
NOVO Technical Handbook - NE41 15013-02 v2.0
Remove a transmitter by position
This method allows removal of a peripheral from the first 8 positions. It can be
used if the position of the peripheral is known but activation is not possible for any
reason.
When in
Remove transmitter
function, press the
Extra button (B3)
to enter the first
position. The unit will play a short beep indicating the position. Press
Extra button
(B3)
to step to the next position. After each step, NOVO will play a number of short
beeps corresponding to the current position chosen. At the desired position, press
and hold the
Alarm button (B1)
to remove the transmitter at that position. NOVO will
play a confirmation sound and return to Service Menu.
Note that this function only allows for removal from the first 8 positions. To remove a
Plug&Play peripheral that can not be activated use
Remove all transmitters
, perform
the removal via CMP or use a software programmer.
Remove all transmitters
When in
Remove transmitter
function. Press and hold the
Alarm button (B1)
until a
short tone is played in the loudspeaker. Release the
Alarm button (B1)
, press and
hold until a confirmation tone is played. All radio peripherals have now been erased
and unit will return to Service Menu.
Set external Mobile antenna to On/Off
This function is only available in units that support GSM or 4G (MOBILE) as a carrier.
Unit plays a voice message to indicate the current antenna status. To change the
status, press and hold the
Alarm button (B1)
until the new status is indicated by a
voice message.
NOVO returns to Service Menu after 10 seconds of inactivity.
NOVO indicates that the function has been chosen by LED L2 flashing and LED L1 on.
The unit will automatically return to Service Menu after execution.
Change Home/Away/Passive to On/Off
When this function is chosen the unit will play a voice message indicating the current
status. To change status, press and hold the
Alarm button (B1)
until the new status is
indicated by a voice message.
NOVO returns to Service Menu after 10 seconds of inactivity.
NOVO indicates that the function has been chosen by LED L2 flashing and LED L1 on.
The unit will automatically return to Service Menu after execution.
When toggling Home/Away/Passive to
On
the unit will do the following:
• Configure
Reset button (B2)
to reset
Passive timer
.
• Set Passive timer to the configured interval (default value is 24 hours).
• Start the Passive timer countdown.
• Configure alarm type for
Extra button (B3)
as Home alarm type. The unit will enter
Home mode by default.
