Leggett & Platt Vertex VA0277, Руководство по эксплуатации

Страница: 7 / 14


O-ring cut, cracked or twisted. Replace o-rings
Tool leaks air when actuated operation weak

Piston o-ring damaged. Replace o-ring

O-rings cut or cracked (valve area). Replace o-rings

Trigger defective. Replace trigger
Note: some air may leak from trigger when actuated, this is normal. If leaking is excessive
where it affects tool operation then trigger should be replaced.
LACK OF POWER; SLOW TO CYCLE

Tool dry, lacks lubrication. Use Vertex air tool lubricant

O-rings cut or cracked. Replace o-rings

Dirt/tar build up on moving parts. Clean, lubricate with lithium grease.

Check valve/trigger dirty. Clean, lubricate

Competitors valve parts used. Use only genuine Vertex repair parts

Broken return spring. Replace spring

Air pressure too low. Check air supply
REPAIR
Rail and Carrier (Magazine)
1. Remove VH0026, 4-40 X ¼ SHCS .