5. Remove
¼ - 20 SHCS VH0461
.
6. Remove
slide VC9103
by sliding it away from teeth area and pulling it up and out of
carriage.
7. Remove the jaw assembly from carriage.
8. Using pin punch, drive out (2)
VH0458 pins
from
jaws VC9104, VC9105
and
VC9107
links.
9. Drive out
pin VH0672
from links and
clevis VC9117
.
10. Remove
set screw VH0456
from clevis.
11. Remove clevis from piston rod. Apply heat if needed to breakdown thread lock
adhesive on threaded end of piston rod.
12. Re-assembly is in reverse order.
13. Orient links per drawing and fasten to clevis using
pin VH0672
. Links should be free to
move.
14. Connect
left jaw VC9104
to the left link by driving
roll pin VH0458
into aligned holes.
15. Connect
right jaw VC9105
to the right link by driving
roll pin VH0458
into aligned
holes. Make sure to match the correct jaw with the correct link for tool to operate
correctly.
16. Screw short threaded end of
piston rod VC9113
into clevis using Loctite (242 or 243
blue) on threads.
17. Insert rod and jaw assembly through carriage.
18. Install
bumper VC9120
and
spring VC9123
onto piston rod per drawing.
19. Apply Loctite (242 or 243) to long thread of piston rod and screw
piston VC9114
firmly
onto piston rod.
20. Apply Loctite (242 or 243) to remaining threads and tighten
nut VH0454
in place.
