Legacy LEGACY24100, Руководство пользователя, Страница: 3 / 20

2
User manual
www.connectinglegacy.com
1. Introduction
The Energy storage pack is an essential component of the photovoltaic power generation system. It can provide
electricity for the connected load, and it can also store photovoltaic solar modules, fuel generators, or wind
energy generators by charging the remaining energy in case of emergency. When the sun goes down, energy
demand is high, or there is a power outage, you can use the energy stored in the system to meet your energy
needs at no additional cost. In addition, the energy storage Pack can help you achieve energy self-consumption
and ultimately achieve the goal of energy independence.
According to different power conditions, the energy storage PACK can output power during peak power
consumption, and can also store energy during low power consumption. Therefore, when connecting the
matching photovoltaic modules or inverter arrays, external equipment is required to match the energy storage
the working parameters of the pack to achieve the highest operating efficiency. For a simple diagram of a typical
energy storage system.
Figure 1 Energy storage System Overview
It is very important and necessary to read the user manual carefully before installing or using the battery.
Failure to follow any of the instructions or warnings in this document can result in electrical shock, serious injury,
death,
or may damage the battery and the whole system.

If the battery is stored for a long time, it is requirement that they are charged every three to six months, and
the SOC should be no less than 80%,after fully discharging,The battery needs to be recharged within 12
hours.

Do not expose cable outside;Do not use cleaning solvents to clean the battery.

All battery terminals must be disconnected before maintenance.