Loading Your Grease Gun
Cartridge Loading
Suction Loading
Filler Pump Loading
Pull follower rod from barrel
and lock into place.
Pull follower rod from barrel
and lock into place.
WARNING:
Do not load gun with air operated
grease pump. Damage to unit
will occur and warranty
will be voided.
Unscrew barrel from head.
Unscrew barrel from head.
Wipe bulk filler nipple until clean.
Remove cap from end
of grease cartridge
Insert open end of gun barrel
two inches below surface of grease.
Insert bulk filler nipple
into loader pump receptacle.
Insert cartridge into barrel,
open end down.
Slowly pull back follower rod
to draw in grease. Pull follower rod
back all the way and lock into place.
Pump grease until 8 inches of follower rod
is exposed.
(Between the follower rod handle and barrel
cap)
Remove pull tab from top
of grease cartridge.
Make sure cartridge is pushed
down completely.
Screw barrel back into head.
Pump grease until barrel is full.
(When barrel is full, rod can be pulled out
without spring tension)
Screw barrel into head until snug.
Unlock follower rod and push into barrel.
Release follower rod.
Unscrew barrel slightly.
(Approximately two revolutions)
If no bleeder valve is installed,
unscrew barrel slightly.
(Approximately two revolutions)
(Skip this step if bleeder valve is installed)
Push follower rod into barrel.
Release follower rod.
Release follower rod.
Prime.
(see “Priming Your Grease Gun”)
Push follower rod into barrel.
Push follower rod into barrel.
Screw barrel into head.
Depress bleeder valve to release air.
(If bleeder valve is installed)
Prime.
(see “Priming Your Grease Gun”)
Prime.
(see “Priming Your Grease Gun”)
Begin greasing.
Begin greasing.
Begin greasing.
Workforce
®
Manually Operated Grease Guns
Part No.: L1025, L1310, L1320, L1325,
L1350, L1355, L1355C
Priming Your Grease Gun
• Point outlet up at least 45 degrees.
• Using slow, complete strokes, stroke handle
repeatedly until grease flows without air.
(Should require 10 - 20 strokes)
Greasing a Zerk (Grease Fitting)
• Press coupler onto zerk.
• Keep coupler and zerk as closely aligned as possible.
• Begin greasing.
•
To Remove Coupler From Zerk:
• Tilt coupler to one side, twist and pull.
Failure to follow above procedure may result in damage to coupler or fitting.
Ph: 319.373.7305
[email protected]
legacymfg.com
INS1000
(Published 2013-11-15 Revised 2022-02-15)
Workforce is a registered trademark of Weems Industries, Inc.
Legacy Manufacturing Company
Marion, IA 52302 USA
L1025
L1320
L1310
L1325
L1355
L1350
L1355C
