LeeBoy 8616B, Руководство по эксплуатации, обслуживанию и запасным частям

Страница: 97 / 287

Conveyor Wear Plates
There are four wearplates on the conveyor. Spraying
down the hopper before and after paving prevents
asphalt buildup that can damage or clog the wearplates.
(Figure 5-26)
1
1
2 2
Figure 5-26. Conveyor Wear Plates
1 - Wear Plates
2 - Conveyor Chains
If the conveyor wearplate(s) needs to be replaced,
follow these procedures:
1. Position paver on a ramp.
2. Remove all guards over the conveyor floor and front
lip panel.
3. Remove main conveyor chains.
4. Remove front conveyor idlers.
5. Remove bolts from rear tube assemblies.
6. Remove the 24 bolts holding the floor onto the
frame.
7. Using a hoist, lift wear plate out of the paver.
8. Clean the frame.
9. Insert new conveyor plate onto the frame.
10. Coat the bolts with thread-locking adhesive and
tighten the new conveyor plate to the frame.
11. Torque bolts to 180 ft. lbs. (244 N.m).
12. Place rear drive assembly back in place.
13. Place thread-locking adhesive on bolts and torque
to 180 ft. lbs. (244 N.m).
14. Tighten adjuster against assembly to keep from
slipping.
15. Place front idler assemblies back in place.
16. Place main conveyor chains in and adjust chain
tension. Once adjusted, torque all idler hold down
bolts to 180 ft. lbs. (244 N.m).
17. Adjust tension bolts tight against assembly when
done and lock jam nuts.
18. Place all guards over conveyor chains and front lip
panel.
19. Grease bearings by using grease blocks on each
side below hopper wing.
NOTE: Remove the inner seals from replaced
bearings in the tubes to allow grease to
enter into the bearing area.
LeeBoy 8616B Conveyor Paver 5-24
NOTE: Remove the inner seals from replaced
bearings in the tubes to allow grease to
enter into the bearing area.
10. Place conveyor shaft into the inner conveyor
sprocket.
11. Insert bolt into shaft.
NOTE: The outer conveyor sprocket must be
aligned with the inner sprocket.
12. Rotate the outer sprocket on the shaft until properly
aligned.
13. Reinstall the outer bearing and outer sprocket.
14. Place thread-locking adhesive on the bolt and
torque to 180 ft. lbs. (244 N.m).
15. Reinstall the conveyor and drive chains and adjust.
16. Grease bearings in the tubes by using grease
blocks on each side below the hopper wing.