LEDX Mamba 4000 X-pand, Инструкция по эксплуатации

Страница: 5 / 8

Programming
The lamp can be programmed to adapt to your own wishes: Make 4 quick
presses of the switch to enter the programming mode - the lamp lights up.
Make 1 short press at a time, you get an answer with a blink from the lamp
that tells you which position you are in, e.g. 3 presses with signal between
each press, the lamp then flashes 3 times. When you are done, make a long
press - the light goes out. Test so that you are in the position you want. In
position 1, the lamp lights up directly when it is connected to a power source.
Mode 1 should not be used with LEDX batteries, butMode 1 should not be
used with LEDX batteries, but only with an external power source via LEDX
Light's protection cable.
Mode 1 should not be used with LEDX batteries, butMode 1 should not be
used with LEDX batteries, but only with an external power source via
LEDX Light's protection cable.
Operating time:
The time may vary with the temperature and condition of the battery
When the battery is about to run out of maximum power, the lamp automa-
tically goes down to about 350 lm and continues to light for about 1 hour,
then the light drops to about 120 lm and lights for another about 1 hour.
Backup battery:
About 350lm for 70 minutes, a total of about 120lm for 2.5 hours.
Push Mode Power
2% Power
6% Power
20% Power
40% Power
80% Power
100% Blink
1 1 x 1
2 2 x x x 2
3 3 x x 3
4 4 x x x x x x 4
5 (default) 5 x x x 5
Operation
time at 20°C 125h 45h 12h
30min 6h
45min 3h
45min 2h
30min