English
Recessed wall light (LC-EL-125-WW) - Assembly instructions
Please read these installation instructions
carefully before installing this product and
keep them for future reference.
1. Safety instructions
The product may only be installed by an
authorized electrician. Protection against
electric shock must be ensured when working
on electrical equipment. Disconnect the building-
side connecting cable from the power supply
and secure it against being switched on again.
To do this, trip the corresponding circuit breaker
of the house installation.
Operate the product only when it is working
properly.
In the event of a fault, do not touch the product.
Immediately turn off the product at an external
switch. In the event of contact or continued
operation in the event of a fault, there is a
danger to life due to burns, electric shock or
fire.
This is how you detect an error:
the product does not work properly (e.g.
cannot be switched on)
the product smokes, crackles or smells burnt
the product overheats (discoloration, also on
adjacent surfaces)
Do not operate the product again until it has
been repaired and checked exclusively by an
authorized electrician!
2. Intended use
The product may:
only be operated with a voltage of 230V
~50Hz.
only be connected according to protection
class I (one).
only be used in accordance with protection
class IP54.
not be subjected to strong mechanical
stresses.
not be changed or modified.
not be operated with an external dimmer
The product is not intended for operation by
children. Ensure that children do not come to
any harm with the product, e.g. by being burned
on hot surfaces or by electric shock. If the
product is not used as intended, especially if
moisture enters the product, there is a danger
to life from burns, electric shock or fire.
3. Maintenance & care
The following environmental influences may
have undesirable effects on the surface of the
product:
high salt content in the air
Detergent
other chemical substances (e.g. mold
remover)
Protect the product by taking appropriate
measures to avoid changes to the surface.
First disconnect the entire product from the
power supply and allow it to cool down before
carrying out any cleaning or maintenance work
on the product.
Clean the product regularly - only with a slightly
damp, soft and lint-free cloth.
4. Storage
The product must be stored in a dry place,
protected from contamination and mechanical
stress.
After damp or dirty storage, the product may
only be operated after a condition check by an
authorized electrician.
5. Disposal
[European Union]
Do not dispose of the product in household
waste! Products with this symbol must be
disposed of in accordance with the Directive
(WEEE, 2003/108) on waste electrical and
electronic equipment via the local collection
points for waste electrical equipment!
6. Heat dissipation
Operation in excessive ambient temperature or
by external heating shortens the service life.
Suitable measures must be taken during
installation to ensure heat dissipation (heat
transfer). No liability is accepted for damage
resulting from corresponding improper use.
04/2022
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach,
www.leds-com.de
, Tel. +49 (0) 2161 - 5 75 99 76
