Rev. May-21
7 Color SMD Slimline Golf Cart Underbody Kit
Warning:
Please check your state and local laws before installing this LED underbody kit. Every state has different policies and
procedures in place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while
using this underbody kit. This kit is for off-road use only.
Warning:
The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will
void all warranties.
The control box that is used to power the underbody tubes must be installed in a dry location inside of the vehicle! Having this part
exposed to water or the elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will VOI
D all
warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED UNDERBODY KIT.
Golf Cart Underbody Kit Includes:
•
(4) 24-Inch Tubes
•
Control Box
•
Wireless Remote
•
Underbody Tube Brackets
•
Zip Ties
•
Large Screws
Golf Cart Underbody Kit Installation:
1.
Arrange the tubes out on the ground and test the kit to ensure
proper functionality before installing.
2.
Temporarily power your kit with any 12-volt source to ensure it is
functioning properly before you move forward with the installation.
Simply connect the red wire from the control box to the positive
terminal on the vehicle
’
s battery and the black wire from the control
box to any good ground source. Power the kit and once you have
determined it is functioning properly, remove power from the kit.
3.
Before mounting the underbody tubes, please refer to the
schematic below. The underbody tubes on this kit must be installed
in a specific way. This layout ensures all lighting patterns are
properly synchronized and displayed correctly.
Note:
Each underbody tube daisy chains to the next with the
included 6 feet of power wire and modular connectors except the
two last tubes from each channel.
4.
Once the kit is laid out, and you have determined the kit is functioning properly, you can proceed with the rest of the
installation.
5.
Optional
: Raise and support the vehicle.
6.
Be extremely aware of the location of the brake lines and fuel lines and do not mount any of the underbody tubes
too close to the exhaust. Leave at least 8 inches between the exhaust and the underbody tubes. Keep the tubes and
the power wires away from any moving parts.
Note:
3 brackets are provided for each tube, one for each end of the tubes as well as one for the center of the tubes.
7.
First, mount the front tube to your Golf Cart
with the male connector facing the driver’s side, using the include
d
mounting brackets. Make sure the tube is at least 8 inches away from any direct heat source and away from all moving
parts.
8.
N
ext, mount the driver’s side
with the male connector facing the rear of the Golf Cart, using the included mounting
brackets.
9.
Next, mount the rear tube with the female connector facing the passenger side of the Golf Cart, using the included
mounting brackets.
