1/7
Ÿ
Securely mount the Hueda Controller
Ÿ
This product is intended to be installed and serviced by a qualied licensed electrician. Install in accordance
with the National Electric Code, and local regulations.
Only power with a regulated (listed) constant voltage
Class 2 power supply (12-24V DC Max). Failure to use a Class 2 power supply may cause re or serious injury
and will void the limited warranty.
Ÿ
Ensure applicable wire is installed between driver, xture and any controls in between. When choosing wire,
factor in voltage drop, amperage rating and type (in-wall rated, Plenum rated, wet location rated, etc.).
Inadequate wire installation could overheat wires and cause re.
Ÿ
This product is rated for indoor installation and only for dry locations. Do not install in washrooms or areas near
water (or the possibility of in the future).
Ÿ
Do not modify this product beyond the instructions in this guide or the limited warranty will be voided.
Ÿ
Wiring diagrams in this installation guide for basic installations. Please carefully review your installation before
proceeding with a qualied electrician familiar with low voltage wiring.
Ÿ
Never install the HUEDA
™
Controller in with other high voltage Junction Box as there is a risk of shock hazzard!
National Electric Code requires electrical conductors to be separated by a barrier within the box or in a
separate box!. Install only in the provide Junction box.
IMPORTANT NOTE
Install Hueda DMX controller in a separate box rated for Low voltage use. NEC codes requires conductors shall not be
placed in any raceway, compartment, outlet box, junction box, or similar tting with conductors of electric light or power.
Safety & Warnings
Before you begin, read all warnings and installation instructions.
Wire Ends
:
Exposed wire should not be more than 6- 8 mm long & solder tip (tinned). Do not allow Wires to cross and insure
all exposed wire is fully inserted into the screw terminals. Hand tighten screw terminals. Use 24 to 18 AWG
gauge wire for output terminals.
WIRE 6-8MM (0.25-0.30”)
Included Items in Box
Ÿ
CAT5 Wire
Ÿ
Mounting Junction Box
Ÿ
Instructions
INSTALLATION SHEET
HUEDA
™
-Multi Zone LED Controller
INSTALLATION SHEET
HUEDA
™
-Multi Zone LED Color Controller
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.4 10/19/15
Copyright © 2015 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
