PENDANT FALSE CEILING
INSTALLATION INSTRUCTIONS
XOOTUBE IP40
LED Linear
™
GmbH
Pascalstraße 9
47506 Neukirchen-Vluyn
Germany
Phone +49 2845 98462-0
Fax +49 2845 98462-120
ENGINEERED IN GERMANY
Ar
t. # 3
3100019
Attention: Do not touch LEDs. Fragile!
Electrostatic discharges can damage the LEDs.
Ø 12
Supplied accessories
Supplied accessories
Required tools
Required tools
General Safety Instructions
• Read the instructions for installation and commissioning.
• Pass the instructions to the customer for safekeeping.
• Do not remove the factory label of the luminaire.
• Please note the national installation and accident prevention regulations
during installation.
The installation must be performed only by a trained electrical specialist.
• Damaged cables may only be changed by trained electrical personnel.
• For improper installation or any subsequent change to the luminaire no
liability is accepted.
• The light source of this lamp may be replaced only by the manufacturer or
an authorized service technician or a similarly qualified person.
• LED lamps (without IP67 protection) must not be cleaned.
• Clean the luminaire regularly with a smooth damp cloth. Only use
solvent-free cleaning agents. Attention: previously cut off the mains supply
and allow system to cool down.
• To protect the surface from dirt and fingerprints, we recommend the use
of protective gloves during installation.
• The disposal of the system must be carried out on the disposal of
electronic products in accordance with the EU Directive WEEE (Waste
Electronical and Electronic Equipment).
• In order to answer technical queries, please contact our project
management respectively our worldwide branches and distributors.
Please send your request to [email protected].
Mains voltage / connection
• Check that there is no voltage of the system prior to installation and
maintenance. Beware of electric shock!
• Only use converters of the correct voltage.
• It is not allowed to use the luminaires with altered or damaged connector
cables.
• In case of a three-phase installation do not interrupt the neutral conductor
of the electronic ballasts.
• Electrically operated (Constant Current) LED modules must not be
secondary side connected.
• Avoid overvoltage at the electronic control gear.
• The cable must not cover the light-emitting portion.
• Connecting and disconnecting the luminaire and the control gear under
present voltage can cause damage to the components.
• Mismatched luminaires and control gears can damage each other.
• Wrongly polarized cables damage the luminaire.
• The installation of a Dali system may only be performed by trained
personnel. Pay attention to any necessary mains voltage resistance of the
Dali operating device.
• Only suitable dimmers must be used for dimming. Observe the manufacturer‘s
instructions. Not suitable dimmers can damage the whole system.
• Terminals in accordance with EN 60998-2-1 or EN 60998-2-2 must be used
for connecting the lamp to the power grid.
Environment
• Pay attention to the allowable ambient conditions under which the luminaire
may be operated.
• Install the luminaire in a place where it is not exposed to direct sunlight or
heat sources.
• Ensure that the recessed version is not covered with insulating material.
• Do not cover luminaire and control gear to prevent overheating.
• Pay attention to the minimum distance between luminaire and lighted
object.
• Be careful with allowable floor loads in case of ceiling mounting of the
luminaire.
• Exterior lighting should be used only after sunset until sunrise.
VERTICAL PENDANT
©
LED Line
ar GmbH / All right
s r
es
er
ved, subject t
o change / T
echnic
al amendment
s and gr
aphic
al pr
es
ent
ation ar
e subject t
o change
. E
dition 01/
2018
