SP108E Digital Wi
-
Fi Controller
App: LED Shop
Contents
SP108E digital Wi
-
Fi controller
Small flat head screwdriver
NOTE:
T
his controller
will only work on a 2.4G network. It will not connect to a 5G network.
Wiring
To get started, unravel the LED strip from the roll. Connect the wires to the terminals in the controller
and tighten the screws to secure the connection.
(Figure 1.)
Please be aware of the arrows on the flex strip. The direction indicates the flow of current. Make
sure that you are connecting from the back end of the arrow. Reversing this will
cause
the strip
not to illuminate.
Figure 1.
Black
wire to
GND
Green
wire to
DAT
Red
wire to
VCC
Blue wire does not get connected
2.2. You can now connect the driver to the controller as shown in
Figure 2.
:
Figure 2.
Plug in the barrel connector OR wires
from the driver to the controller.
Negative
to
GND
Positive
to
VCC
2.3. To confirm that all of your connections are successful, supplying 110V AC power to the driver should
result in the flex strip lighting up. If your lights are illuminated, please proceed.
[3] App Download and Setup
3.1. Download
LED Shop
from your device’s app store (Google Play or App Store).
There are two ways to connect the controller to the network:
[A] AP mode
will allow you to connect your device directly to the controller.
1. Within 20 seconds of powering the controller, go to your device’s WiFi settings. Find and connect
to
SP108E
as you would with any network.
2. Launch the app. The app will instantly display and connect to the SP108E controller. Proceed to
Step 3.2
.
LED Lights Canada
Toll Free
: 1-800-677-2698
4404 97 St NW
Local
: 780-800-0059
Edmonton, AB T6E 5R9
1
Email:
The SP108E can control up to
2048 pixels.
This can be done
by running the
DAT
wire
in series from the end of the first
strip to the
beginning of the last
flex strip.
SKU: CTR750
