background image

RATPAC

Connector Kit

INSTRUCTION MANUAL

Rio Rancho, NM, USA

www.lectrosonics.com

Fill in for your records:

  Serial Number:

  Purchase Date:

Build a right angle TA5 or TA3 connector.

Содержание RATPAC

Страница 1: ...RATPAC Connector Kit INSTRUCTION MANUAL Rio Rancho NM USA www lectrosonics com Fill in for your records Serial Number Purchase Date Build a right angle TA5 or TA3 connector ...

Страница 2: ...nt cable clamp from turning Threaded hole for set screw A standard TA connector sleeve is used with either a 3 pin or 5 pin insert and a modified cable clamp The insert nests inside the sleeve and is held in place by a spacer and metal retainer The sleeve is held in place by two set screws in the machined aluminum housing The shrink tubing can be used wherever it is useful to provide an additional...

Страница 3: ...nder the cable clamp before it is crimped Also see Step 6 below about grounding of some lavaliere mics Step 1 Install the set screws into the right angle housing Turn them in a few turns but do not tighten them Slide all the parts onto the cable in the order shown above Step 2 Strip the outer insulation of the cable back about 1 2 inch Strip the insulation on the inner wires back about 1 8 inch St...

Страница 4: ...sonics Inc will pay for the cost of returning your equipment to you This warranty applies only to items returned to Lectrosonics Inc or an authorized dealer shipping costs prepaid within one year from the date of purchase This Limited Warranty is governed by the laws of the State of New Mexico It states the entire liablility of Lectrosonics Inc and the entire remedy of the purchaser for any breach...

Отзывы: