Lectrosonics DM1612, Справочное руководство, Страница: 22 / 48

22
DM Series Digital Matrix Processors
Preset Setup Screens
TopMenu - Presets
Navigate to the Top Menu and rotate the encoder knob to select the
Presets item as shown in this example. Press the encoder knob to
move to the Preset Control screen.
Preset Control - Recall
Select REC to recall an existing preset configuration from memory.
Rotate the encoder knob to select the preset, press OK to confirm the
selection, then press the encoder knob to initiate the action.
Preset Control - SetToFac
Select FAC to reset the contents of a memory preset location to factory
default settings. Rotate the encoder knob to select the preset, press OK
to confirm the selection, then press the encoder knob to initiate the
action.
Preset Control - PowUpDef
Select DEF to view/change the setting for the powerup default preset.
Rotate the encoder knob to select the preset, press OK to select the
preset, then press the encoder knob to make the change. The next time
the device is powered up, the selected memory preset will be made
active.
Preset Control - Store To
Select STO to copy the contents of the active setup to a selected
memory preset location. Rotate the encoder knob to select the preset,
press OK to confirm the selection, then press the encoder knob to
initiate the action.
Preset Control Screens - Using the OK item on all screens
Preset Control screens are different from the other screens.
Because actions available on this screen result in permanent
changes to the nonvolatile memory within the device, a two-step
sequence is required to make a change.
As a safeguard, the OK button must be pressed to confirm an
action before pressing the encoder knob to initiate the action.
In the upper example, the STO (store active setup) action has
been selected, with preset 1 as the destination. In the lower
example, the OK button has been selected. When the encoder
knob is pressed, preset 1 will be overwritten with the contents of
the active setup (
Act: 3 in the display).
If the OK item had not been selected, pressing the encoder knob
would have had no effect.
The Preset screens require an additional step to apply the action selected - the OK button.
This provides a safeguard against accidental preset activities or overwriting a stored preset.
NOTE: STO is typically used the permanently store changes made to a preset
configuration so that they are not "forgotten" when the device is powered down.