100 Series
Wireless Microphone System
SYSTEM SETUP PROCEDURE
Rio Rancho, NM, USA
www.lectrosonics.com
Страница 1: ...100 Series Wireless Microphone System SYSTEM SETUP PROCEDURE Rio Rancho NM USA www lectrosonics com ...
Страница 2: ...en the transmitters are turned off find new switch settings or re position the receiver The RF LED should extinguish when the associated transmitter is turned off UCR100 receiver Push outward on bottom then rotate to open UH400A transmitter Slide battery door out then swing open After installing the battery turn the unit on and check to see that the Power LED is brightly lit LM transmitter Push ou...
Страница 3: ...ff 20 dB to 10 dB Green Off 10 dB to 0 dB Green Green 0 dB to 10 dB Red Green optimum Greater than 10 dB Red Red NOTE This step only applies to cameras and camcorders that offer manual audio level control during recording If your camera or camcorder offers AGC automatic gain control only skip this step and go to step 8 Set the manual input level control on the camera or mixer to a point just above...
Страница 4: ...use When the talker begins speaking again the background noise will be buried by the talker s voice until the next pause in speech occurs The noise buildup is caused by the AGC circuit in the camera trying to adjust for a constant level It is not the fault of the wireless system Manually adjust the UCR100 output level control to minimize the breathing effect generally a lower setting Receiver Outp...
