USB
MobileHS
User Manual
Chapter 3: Installation
LeCroy Corporation
13
3.4 Your First USB Recording
After installing and launching the software, test USB
Mobile
HS by performing the
following steps:
Step 1
Connect a USB cable to each of the two connectors on the USB
Mobile
HS
module, and then connect the other ends to the USB device under test and USB host
system.
Step 2
Select
Recording Options
under
Setup
on the Menu Bar.
Step 3
Select the
General
tab to display the default settings such as “Snapshot” and
1 Mbyte buffer size. For the first recording, leave the settings unchanged.
Step 4
Click
OK
to activate the recording options you selected.
Step 5
Turn on the USB devices that are to be tested and cause them to generate USB
traffic.
Step 6
Click
on the Tool Bar.
USB
Mobile
HS starts to record the USB traffic immediately. After 1 MB of traffic
has been recorded, the Analyzer uploads the data and displays the packets in
the trace window.
Содержание USB Mobile HS
