6
SECTION 3 : INSTALLATION
Your Cloud 9 table comes completely assembled and ready to use.
Once the table is unpacked, follow the “Moving Your Table” instructi ons below.
Moving Your Table
without using proper safety procedures/equipment. DO NOT turn the table on its side for any
reason. Lift your table by grasping fi rmly from the bott om of the metal frame underneath the
upholstered top. Do not try to lift from the upholstered top.
CAUTION
Your table is very heavy - extreme cauti on should be used to avoid injury
to yourself, others around you, and your table. DO NOT lift or move
Basic Setup Instructions
Once your Cloud 9 table is positi oned for use, follow these steps:
•
Plug the power cord into a grounded outlet that is properly rated for the table.
•
Arrange and secure the power cord so it will not create a tripping hazard.
•
Place the hand and foot controls in locati ons where they are safe and accessible.
•
Ensure the controls are not in danger of being crushed by the lift or ti lt mechanisms.
•
Follow the “Leveling Your Table” instructi ons on the next page.
Leveling Your Table
Leveling, or balancing, your table is very important during initi al setup and routi ne maintenance.
Your Cloud 9 table is equipped with leveling feet that can adjust to uneven fl oors.
To adjust the leveler feet:
1. Place the table in the positi on you plan to use it.
2. To determine which foot needs adjusti ng, att empt to “rock” your table. If there is any
movement, the leg that is lift ing is the one that will need adjusti ng.
4. Using your hand, or a wrench if necessary, turn the leveling foot in the needed directi on.
(Counterclockwise will lower the overall height, clockwise will raise the overall height)
Table Accessories
All Cloud 9 tables come with outlets at both ends, specifi cally designed for providing a fi xed
locati on for FacePillow platf orms, salon pillows, and other accessories.
See the Living Earth Craft s website for all available acces-
sories that will fi t into the table outlets.
Be certain to arrange the power cord and foot control so they will not
create a tripping hazard, and will not be in the path of moving parts.
