Leander 950 Series Operator Manual & Warranty
9
Cushions
The LEANDER TABLE obtains standard density of foam is used for support and
comfort for patients.
Arm Rests
Arm rest cushions are located at either side of the head section. These cushions
are provided for patient comfort and allow for reduced tension in the thoracic spine
during treatment. They are not meant to support the weight of the practitioner.
Head roll Paper System
Head roll paper system (see figure 14). Hanger (A) is provided for a 12-1/2 inch
paper roll on the right side of the head section. Flexible plastic guide rod (B) keeps
the paper down and in place between the head cushions. Paper cutter (C) is
provided on the left side of the head section.
Foot Switches
The motorized CPM flexion distraction and uplift features of the table are both
operated by foot switches.
The flexion motor is started or stopped by simply pressing the “Start” or “Stop” side
of the On/Off pedal. The end of the pedal “away” from the cord is the “Start” side
and is marked with a green dot. The end of the pedal “at” the cord is the “Stop”
side and is marked with a red dot.
The uplift adjusts to any preferred height by pressing and holding the uplift pedal
until the table reaches the desired level. The end of the pedal “away” from the cord
is the “Up” side. The end of the pedal “at” the cord is the “Down” side.
Leveling Feet
Under each corner of the table are leveling feet. These are smooth faced,
adjustable height levelers provided to accommodate irregularities in floors.
To adjust the feet use a thin 7/8 inch wrench while the table rests on the floor or
simply lift the table and turn them by hand. The feet are threaded into the legs and
will change height when twisted.
Figure 14
Head roll paper system
components.
