Leader LV 5837, Инструкция по эксплуатации

Страница: 55 / 106

47
7. LISSAJOUS DISPLAY
F•1
F•2
F•3
F•4
F•5
F•6
7.2 Configuring the Lissajous Settings
To configure the Lissajous display settings, press LISSAJOU SETUP in the mode menu.
→
DISPLAY to LISSAJOU
→
LISSAJOU SETUP
→
Figure 7-2 LISSAJOU SETUP menu
● LCH: CH 1 - CH 16 / D1 - D8 / Lt
● RCH: CH 1 - CH 16 / D1 - D8 / Rt
Select the channels to assign to Lch and Rch of the Lissajous display. The channels that
you can select varies depending on the F•6 GROUP setting.
● METER SETUP
Configure the meter settings. For a description of the settings, see section 6.2,
“Configuring the Meter Display Settings.” However, F•6 GROUP is not displayed.
● AUTOGAIN: ON / OFF
Turn the AGC on or off. When set to ON, the gain is automatically adjusted so that the
Lissajous curves fit within the scale. This is valid when the input signal is in the range of
-45 to 0 dBFS.
● GROUP: GROUP1 / GROUP2 / ALL / 1-8 / 9-16
Select the display channels.
[Reference] GROUP1, GROUP2 → See section 4.4.7, “Mapping Measurement Channels.”
GROUP1: In the meter display, channels that were selected using GROUP1 on the
assign menu are displayed. In the Lissajous display, two channels that you
select from this group are displayed.
GROUP2: In the meter display, channels that were selected using GROUP2 on the
assign menu are displayed. In the Lissajous display, two channels that you
select from this group are displayed.
This cannot be selected when GROUP2 is OFF.
ALL: In the meter display, all channels are displayed. In the Lissajous display,
two channels that you select from all channels are displayed.
1-8: In the meter display, channels 1 to 8 are displayed. In the Lissajous display,
two channels that you select from all channels are displayed.
9-16: In the meter display, channels 9 to 16 are displayed. In the Lissajous
display, two channels that you select from all channels are displayed.
F•2
F•2
MODE
USO
RESTRITO