Leader LV 5770SER42, Инструкция по эксплуатации

Страница: 22 / 67

4. LISSAJOUS DISPLAY
19
4.6 Mapping Channels
To select the channels that you want to map to the Lissajous display's L and R axes and to
the audio meter, follow the procedure below.
Procedure
AUDIO → F•4 LISSAJOU SETUP → F•6 CHANNEL MAPPING
The channels that you can select vary depending on the input mode and SOURCE SELECT
settings as shown in the following table. The Single Lissajou Lt and Rt are calculated from the
channels that are mapped on the surround display.
The audio thumbnail that is displayed when an LV 5770SER03A, LV 5770SER08, or LV
5770SER09A is installed in the LV 7770 shows an audio meter that contains the channels
that you select here.
For information on the SOURCE SELECT setting, see section 2.1, “Configuring Measurement Signal
Settings.”
For information on the channels that are mapped on the surround display, see section 5.5, “Mapping
Channels.”
Table 4-1 Mapping channels
Multi/Siml Lissajou Single Lissajou INPUT
SELECT
Input Mode
NUMBER of
CHANNELS
L1, R1, L2, R2 L3, R3, L4, R4 L, R
8CH 1ST GRP SELECT 2ND GRP SELECT 1ST GRP
2ND GRP Lt + Rt Single
input mode
16CH CH1 to CH16 (L1 to R8) CH1 to CH16 + Lt + Rt
SDI
Simul mode 8CH ACH GRP SELECT BCH GRP SELECT -
- 8CH D1 to D8 D1 to D8 CH1 to CH8 + Lt + Rt SDI
(Dolby)
Mix mode 16CH 1ST GRP PCM + 2ND GRP PCM
(L1 to R4), D1 to D8 (L5 to R8) 1ST GRP PCM +
2ND GRP PCM +
D1 to D8 + Lt + Rt
- 8CH CH1 to CH8 CH1 to CH8 CH1 to CH8 + Lt + Rt EXT DIGI
- 16CH(OP70) CH1 to CH16 (L1 to R8) CH1 to CH16 + Lt + Rt
- 8CH D1 to D8 D1 to D8 + Lt + Rt EXT DIGI
(Dolby)
Mix mode 16CH CH1 to CH8 (L1 to R4)
D1 to D8 (L5 to R8) CH1 to CH8 + D1 to D8 +
Lt + Rt
EXT ANA - 8CH CH1 to CH8 CH1 to CH8 CH1 to CH8 + Lt + Rt