Leader LV 5770SER42, Инструкция по эксплуатации

Страница: 12 / 67

2. AUDIO DISPLAY
9
● When INPUT SELECT Is Set to EXT DIGI and MIX MODE Is Set to ON
The left half shows external audio channels selected with PCM SELECT.
The right half shows channels D1 to D8, which are the decoded signals of the channels
selected using F•2 INPUT GROUP.
Here F•2 INPUT GROUP CH 1, 2 to CH 7, 8
correspond to channels A1 to A8; and CH 9,10 to CH15,16 correspond to channels B1 to
B8.
In the meter display, cyan
■ marks are displayed above non-PCM signals.
For information on the PCM SELECT setting, see section 2.1.2, “Selecting the Channels to Measure.”
Figure 2-9 AES Dolby display (mix mode)
2.3.3 Turning Dialog Normalization On and Off
When F•1 DECODE MODE is set to DOLBY E, to turn the dialog normalization on and off,
follow the procedure below.
Procedure
AUDIO → F•6 DOLBY SETUP → F•3 DOLBY E DIALNORM: ON / OFF
2.3.4 Turning Pulldown On and Off
When F•1 DECODE MODE is set to DOLBY E, to turn the pulldown on and off, follow the
procedure below.
Procedure
AUDIO → F•6 DOLBY SETUP → F•4 DOLBY E PULLDOWN: ON / OFF