Leader LV 5333, Инструкция по эксплуатации

Страница: 164 / 239

152
13. STATUS DISPLAY
F•5
Procedure
STATUS → F•5 ERROR CONFIG → F•4 ERROR LEVEL → F•3 CABLE ERROR → F•6
next menu
→ F•2 HD WARN LENGTH m: 5 - 80 - 130
● Setting the SD Error Upper Limit
To set the upper limit of cable errors, follow the procedure below. If this value is exceeded,
an error will occur, and the measured value on the status screen will be displayed in red.
Press the function dial (F•D) to return the setting to its default value (250).
This setting is valid when the input signal is SD.
Procedure
STATUS → F•5 ERROR CONFIG → F•4 ERROR LEVEL → F•3 CABLE ERROR → F•6
next menu
→ F•3 SD ERR LENGTH m: 50 - 250 - 300
● Setting the SD Warning Upper Limit
To set the upper limit of cable warnings, follow the procedure below. If this value is exceeded,
a warning will occur, and the measured value on the status screen will be displayed in
yellow.
Press the function dial (F•D) to return the setting to its default value (230).
This setting is valid when the input signal is SD.
Procedure
STATUS → F•5 ERROR CONFIG → F•4 ERROR LEVEL → F•3 CABLE ERROR → F•6
next menu
→ F•4 SD WARN LENGTH m: 50 - 230 - 300
13.6.8 Configuring the Luminance Level Error Settings
To configure the luminance level error settings, press LUMA on the STATUS menu.
The settings that you specify here also apply to the CMP bar in the 5 bar display. The unit for setting the
level is the same as the unit that was specified with
Reference 12.8.1, “5 Bar Screen Description” UNIT.
→ ERROR CONFIG → ERROR LEVEL → LUMA →
Figure 13-_24 LUMA menu
● Setting the Upper Limit
To set the upper limit of luminance level errors, follow the procedure below. An error is
detected when the input signal luminance level exceeds the specified value.
Press the function dial (F•D) to return the setting to its default value (109.4 or 765.8).
F•4
F•6
F•4 F•4 STATUS