LEAB BPC 12-12/40, Быстрый старт, Страница: 11 / 16

9 Operation
9.1 Switching the Device On/Off
The BPC charge booster switches on automatically when the following condi-
tions are fulfilled:
– D+ signal is present (connection for D+ or CAN communication).
– Charge booster is in standby mode.
The BPC charge booster switches off automatically when one of the conditions
is not fulfilled.
9.2 Operating Status
The BPC charge booster indicates the operating status via the LEDs on the
charge booster. An external LED can also be connected.
LEDs on charge booster
LED Status Meaning
LED Status Device inactive (no input voltage)
LED Status Battery is charged
LED Status Reduction in charging current, over-
heating protection (from 70°C surface
temperature)
LED Status Device is ready for operation
LED Status Device in normal operation, charging
current is limited
LED Com CAN communication active
LED Com CAN communication inactive
LED Failure see Error Codes table in Error Codes
[
}
12]
Tab. 2:
LEDs on charge booster
11 LEAB Automotive GmbH Thorshammer 6 24866 Busdorf
LEAB Automotive GmbH 9 Operation