8.1 Connecting an External LED
To connect an external LED, perform the following steps:
1 Connect the anode lead of the external LED to the DC input of the device.
2 Connect the cathode lead of the external LED to the of external LED port on
the device.
ð
The external LED is connected.
8.2 Establishing CAN Communication
The BPC charge booster is used to facilitate easy charging of lithium batteries
from Clayton Power. The BPC charge booster is switched on and off via CAN
communication. In addition, the charge booster automatically detects the re-
quired output voltage.
To activate CAN communication, perform the following steps:
1 Connect one end of the CAN communication cable to a CAN bus connector
on the Clayton Power lithium battery.
2 Connect the other end of the CAN communication cable to the CAN con-
nector on the charge booster.
ð
CAN communication is established automatically during operation.
9 Operation
9.1 Switching the Device On/Off
The BPC charge booster switches on automatically when the following condi-
tions are fulfilled:
– D+ signal is present (connection for D+ or CAN communication).
– Charge booster is in standby mode.
The BPC charge booster switches off automatically when one of the conditions
is not fulfilled.
9.2 Changing the Output Voltage
NOTE!
If you are using a Clayton Power lithium battery and CAN communica-
tion, there is no need to set the output voltage as it is detected automatically.
11
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
LEAB Automotive GmbH
