Troubleshooting BubbleMaster 2000
Shut Down Procedure
1.) Disconnect the BubbleMaster 2000 from the power source.
2.)Remove the bubble extension sleeve if used..
3.) Using a funnel, empty the contents of the fluid reservoir back into the
1 gallon fluid container. This can be done by tipping the unit, and pour-
ing the fluid out of the bubble outlet.
4.) Replace cap on the fluid container to keep dirt and debris from
entering.
5.) Rinse out fluid reservoir and bubble wheels with hot tap water tap
water to remove excess Bubble fluid residue. Using a paper towel wipe
out extension sleeve and bubble oulet.
Empty into sink or appropriate drain.
Bubble Wheel not turning:
Ensure that set screws are secure in bubble wheel motor shaft.
Intermittent bubbles produced.
Ensure that there is enough fluid in the fluid reservoir, and that the bubble wheels are
being submersed in bubble fluid.
5
