●
Always monitor tank fluid level during operation as running the snow
machine without fluid can permanently damage the unit. If you experience
low output, mechanical noise or no output at all, unplug immediately.
Check the fluid level, the external fuse, remote connection and power from
the wall. If all of the above appears to be working correctly plug the unit in
again. If snow does not come out after holding the remote ON/OFF button
down , check the hose attached to the tank to make sure there are no
blockages in the hose.
Operation
●
Plug the power cable into a grounded electrical outlet.
●
Press the red power switch to turn on the machine and make sure the red
indicator located above the power switch is lit.
●
The units can be controlled by DMX or the volume remote control, see
below.
●
Connect the remote control’s male 4-pin plug to the machines INPUT
socket and make sure the red POWER indicator is lit.
Vol ul m e Knob
I ndi cator / Red
4-PI N XLR
I ndi cator / G r een
C abl e l engt h: 10 m
C onnect or: 4-PIN XLR
Funct i ons: On/ Off and Vol um e
●
Press ON/OFF button, once the IN USE indicator lights up green the
machine is ready to operate (during this procedure, the machine’s fan and
motors are operating.)
●
Use the adjustable OUTPUT VOLUME on the volume remote controller to
set an output value between 10% to 100%.
●
Use the AIR VOLUME button located at the rear of the machine to adjust
the fan output volume. When the fan output is increased the snow flakes
produced are smaller, when the fan output is decreased, bigger snow
flakes will be produced. The snow output volume will not be affected.
DMX Control
●
Connect the DMX lead to the DMX-IN socket on the rear of the machine.
●
Test the system by activating the machines selected DMX channel. When
Содержание Arctic
Страница 1: ...Le Maitre Ltd ...
