2
1
9
3
10
4
11
5
12
6
7
8
HOW TO UNPACK BEE HIVE
HOW TO ASSEMBLE BEE HIVE
CONTENTS
Model 303 comes pre-assembled with hand-pleated paper shade on an oiled oak frame.
The electrical cable attachment is included and is very easy to install by following the
instructions below.
MAINTENANCE
Paper shade and wooden frame: Use a dust brush or a mild vacuum setting when cleaning.
Do not use any form of liquid or water on the pleated shade as it will dissolve.
The paper cannot be repaired, but if damaged, you can purchase a new shade.
LIGHT SOURCE
We recommend using an LED bulb to prevent heat damage to the paper shade.
Recommended wattage: 303 small: 6W, 600 lumens and 303 medium: 7W, 800 lumens.
NB:
Max. wattage 20 W LED (E27).
Please follow your area’s environmental recommendations for disposal of all used
light sources.
UNPACKING
1.
Read through the instructions
carefully before you start.
2.
Unpack the electrical cable
attachment and place it on a flat
surface/table top.
3.
Lift out and place the cardboard
insert on a flat surface/table top,
then carefully pull then slide out
the diffuser plate.
4.
Place both hands inside the
handles of the inner cardboard insert
and pull up the safety packaging
with the lamp, up out of the box.
5.
Place the safety packaging and the
lamp on the floor.
6.
Grip the top parts of the legs and
lift the lamp up onto a flat surface/
table top, to avoid damaging the
paper shade.
Instructions for BEE HIVE
Models 303S / 303M
Please read through the instructions before you attempt
to unpack and assemble the lamp
ASSEMBLY
7.
Remove the socket ring from the
socket.
8.
Tilt the lamp and insert the socket
from under the lamp.
9.
Place the socket into the hole
located in the center of the
built-in frame.
10.
Screw on the socket ring to secure
the socket to the built-in frame.
11.
Keep holding the underside of
the socket as you turn and tighten
the socket ring, to stop it from
spinning around.
12.
Fit a light bulb then place the
diffuser plate on the top of the
lamp onto the grooves.
Содержание BEE HIVE 303
Страница 3: ...Made in Odense Denmark ...
