LITE
TIRE PRESSURE MONITORING SYSTEM
COPYRIGHTS LDL TECHNOLOGY
– JULY 2009
1/7
TIRE WATCH
TM
FOR MOTORCYCLE
USER MANUAL
Thank you for purchasing this TIRE WATCH
TM
system. TIRE WATCH will allow you to drive with more confidence and be
alerted in the event of a slow leak or puncture. The setup options for the TIRE WATCH
TM
system are detailed below.
For first time use, follow the instructions below. You may not set the system values as detailed in section
(C) until the following sensor allocation is completed.
A: FIRST USE OF THE DISPLAY
FIG 9 – MENU 06 : FRONT & REAR TIRE IDENTIFIER (ID) ALLOCATION
The first time the display is powered up, it has to verify the unique ID of
the front and rear tire (the unique ID’s are pre-
programmed during manufacture - not allocated to a position - and have to be confirmed now to the display).
Turn ON the display
short push on or
If this learning phase fails dashes will be displayed instead pressure values. Then you will have to start again the ID
confirmation process
Switch off the display and wait 8 minutes, motorcycle stopped, before repeating this phase
If the pressure values are not displayed after several trials, please contact your dealer.
B- KNOW EVERYTHING ABOUT YOUR EQUIPMENT
FIG 1 – DISPLAY BUTTON FUNCTIONS
Note : Permanent back light function
: to activate the permanent back light press and .simultaneously. Do the
same to turn off the permanent back light. The permanent use of the back light uses excessive battery life so its usage is
recommended at night only.
To invert the front and rear wheel unit sensor allocation
FIG 8 – MENU 05 – VALUE INVERSION
ID symbols are blinking
-
Drive faster than 20 Mph until Pressure value
displayed (time out 4mn )
Bt
1
Bt
1
Bt
2
Bt
2
Bt
1
Bt
1
Bt
2
Bt
2
: ON / Scrolling menus/ Validation / Backlight only
ON / OFF / Display Units Setting / Swap from Pressure to
Temperature + backlight (4 seconds)
– Tire Pressure or Temperature information
– Pressure (bar/PSI) or Temperature unit (°C)
– External temperature -
NB : Due to the waterproof nature of the
housing, stabilisation of the temperature reading may take several
minutes.
- 24 Hour Clock
Bt
1
Bt
1
Bt
2
Bt
2
