Rev: 09.20.18
Page 1
CCD-0002197
Removal of the Arm
1.
Roll awning out approximately 1 ft.
2.
Align the hole in the end cap with the hole in the shaft going from the head through the end cap.
3.
Insert a cotter pin through the aligned end cap and head shaft holes on each end of the awning (Fig. 1).
4.
Remove the screw holding the support arm to the head on the awning roll tube (Fig. 1).
SOLERA
®
CLASSIC AWNING ARM
REPLACEMENT INSTRUCTIONS
TI-231
AWNINGS
Moving parts can pinch, crush or cut. Keep clear and use caution.
Make sure the roll tube is adequately supported before removing the support arm assembly. Failure to
do so may result in serious personal injury or property damage.
Always wear eye protection when performing service or maintenance to the coach. Other safety equipment to
consider includes hearing protection, gloves and possibly a full face shield, depending on the nature of the service.
Fig. 1
Fig. 2
Cotter Pin
Upper Mounting Bracket
Awning Rail
Fig. 3
Push to open
5.
Remove the 2 screws securing the upper mounting bracket to the sidewall of the coach (Fig. 2).
6.
Remove the support arm from the head and un-latch it from the bottom bracket (Fig. 3).