L
ippert Components, Inc.
I
nformational
P
ublication
LIP Sheet - 0205 revB
LINC WIRELESS TOUCH SCREEN REMOTE - IDS
Configuring the Remote
1.
Turn the remote on by pressing and releasing the large silver button at the
bottom of the unit (Figure 1). Pressing this same button five times accesses
the Configuration menu after the unit has been configured previously.
2.
Press the “Config” button on the touch screen to begin configuring the remote
(Figure 2). Using the arrow buttons at the bottom of the screen, navigate to
the specific items the remote will control (Figure 3). When the name of the
item appears in the middle of the screen, press the large “Select” button.
3.
Assign an item or “None” to each of the seven function spaces available. A
Confirmation screen will appear on the screen (Figure 4). Press “OK” to save
the configuration or “Cancel” to edit the functions.
Syncing the Remote to the Receiver
1.
To begin syncing the remote to the receiver, both the receiver and the remote
must have power (12V DC for the receiver and the battery in the remote must
have a charge).
2.
Push and hold the black button on the receiver (Figure 6). While the black
button is depressed, push and release the “Light” button on the remote
(Figure 5).
NOTE:
If close enough to the receiver, an audible “click” can be
heard verifying the receiver is programmed to the remote.
3.
Release the black button on the receiver.
NOTE:
To sync a second remote to the receiver,
repeat Steps 2 and 3. Only sync two remote
per receiver.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
