- 15 -
OUTPUTS AND INPUTS CONFIGURATION
OUTPUTS
The outputs are set by default as follows:
-
OUT1:
/
.
-
OUT2:
/
.
-
OUT3, 4:
/
/
/
/
.
Possible operation modes:
-
(normally open)
: the relay is de-energised and the contact is open when the weight is
lower than the programmed setpoint value; it closes when the weight is higher than or equal to
the programmed setpoint value.
-
(normally closed)
: the relay is energised and the contact is closed when the weight is
lower than the programmed setpoint value; it opens when the weight is higher than or equal to
the programmed setpoint value.
-
: the contact will switch on the basis of weight, according to setpoint (see section
SETPOINT
PROGRAMMING
).
-
: the contact will not switch on the basis of weight, but is controlled by remote protocol commands.
-
: relay switching occurs when the weight is stable.
-
: (OUT 1 only): connect to the green light of the signal station.
-
: (OUT2 only): connect to the red light of the signal station.
If the operation mode
is selected and the net functions are enabled, the following options are
also active:
-
: the contact will switch on the basis of gross weight.
-
: the contact will switch on the basis of net weight (If the net function is not active, the
contact will switch on the basis of gross weight).
If net functions are disabled (see parameter
in section
INFO MENU
), by
selecting
the operating mode
will be activated.
-
: relay switching occurs for both positive and negative weight values.
-
: relay switching occurs for positive weight values only.
-
: relay switching occurs for negative weight values only.
+
…
…