LAWO edge, Руководство пользователя

Страница: 19 / 154

edge - User Manual
Version: 1.0.13/1 Exported on: 22 February, 2024 19 / 154
3.3 .edge - Grounding
The .edge frame must be grounded for EMC reasons.
Grounding Instructions
A grounding screw is provided on the opposite side of the frame to the ventilation holes. The images below show the
location of the grounding screw and the sticker that is attached to the side of the frame.
.edge Frame - Position of Grounding Screw
.edge Frame - Sticker (shows PE connection point)
To ground the frame, please read and observe all of the instructions in the "General Safety Information for Lawo Equipment"
booklet delivered with your devices.
Use the M5x12 screw to fasten the grounding cable to the housing. You should use a Torx T25 driver for this purpose.
(E) CAUTION
Each frame must be on the same potential as all other system devices.
ALWAYS use a grounded mains connection, to prevent the device from being grounded through Ethernet or other signal
connections.
The device must be connected to an additional fixed protective ground if it is conductively connected with more than
20 other devices. i.e. more than 20 copper I/O connections. For more information, please refer to the "General Safety
Information for Lawo Equipment" booklet delivered with your devices.