LawnMaster CLGT2410H, Руководство оператора

Страница: 18 / 32

18
OPERATION
INTENDED USE
This trimmer is intended for cutting weed, grass or similar soft vegetation in areas that are hard to
reach, e.g. under bushes, on slopes and edges. It must not be used to work on unusual thick, dry or
wet grass, e.g. pasture grass, or to shred leaves.
This product is intended for private domestic use only, not for any commercial trade use. It must not be
used for any purposes other than those described.
SWITCHING ON/OFF
1. Make sure that the battery pack is installed properly.
2. Press the lock-off switch on either side and hold it in position. Press the on/off switch to switch the
trimmer on (Fig. 10). Once started release the lock-off switch.
3. Release the on/off switch to switch the trimmer off.
ADVANCING THE TRIMMING LINE
The trimmer features a fully automatic single line system. The line will automatically elongate every
time you turn on the trimmer.
NOTE:
Bumping the head to try to advance the line will damage the trimmer and void the warranty.
1. With the trimmer running but NOT trimming, release the on/off switch.
2. Wait 2 seconds and press the on/off switch. The line will extend with each stop and start of the on/
off switch until the line reaches the length of the trimming line cut-off blade.
3. Resume trimming.
Adjusting the line length manually:
1. Switch off the trimmer and remove the battery.
2. Push the advance button located on the trimmer head while pulling on trimming line to manually
advance the line. The line will advance and stop. Push the button again to advance more line
(Fig. 11).
3. Push the button and pull the line out as many times as it takes to reach the line cut-off blade.
Fig. 10
1
2