LAVA Computer MFG Inc.
nSynC-Staging Reference Manual - Rev A05
2 Vulcan St. Toronto, ON
Tel: +1 416 674-5942
www.lavalink.com
Canada, M9W 1L2
Toll Free (US & Canada): 800 241-5282
5 of 10
Status LED lights
Status LEDs
The nSynC-Staging features a red Power LED, which indicates the device is receiving power and
a red Operating Power LED, which indicates if the adapter is receiving the 45W minimum
needed for SimulCharge mode.
There are two LEDs next to the Mode Select Button to indicate if the device is in Forced OTG
mode. When the Mode Button is held down, the Forced OTG LEDs will start blinking. When
you let go, the lights will stay on if you are in Forced OTG mode and off in you are not.
There are also Green and Yellow Ethernet Link LEDs next to each of the four USB-C ports for
mobile devices for a total of eight. Each of these pair of LEDs flash when the mobile device
connected to the corresponding USB-C port is receiving the wired network connection through
the adapter.
Figure 1:
nSynC-Staging case
Note: If the nSynC-Staging is in OTG mode because it is using a power supply that is less than
45 watts, the OTG LEDs will not turn on. These LEDs are only turn on when you manually
switch to OTG using the Mode Button.
