Lauda VC 1200, Руководство по эксплуатации

Страница: 7 / 100

1 Safety
1.1 General safety instructions
n
The devices must only be operated for the intended purpose under the
conditions stated in this operating manual. Any other operating mode
is considered to be non-intended use and can impair the protection
provided by the device.
n
The devices are not designed for use under medical conditions in
accordance with DIN EN 60601-1 or IEC 601-1!
n
The operating manual is a constituent part of the device. The information
in this operating manual must therefore be available in the immediate
vicinity of the device. Also take care to keep this copy of the operation
manual.
If you lose this operating manual, contact the LAUDA Constant
Temperature Equipment service department. The contact details can
be found in
Ä
Chapter 13.4 “Contact LAUDA” on page 91 .
Use of the device results in hazards from high and low temperatures and
from the use of electrical energy. The hazards arising from the device have
been eliminated as far as possible by the design in accordance with the
applicable standards. Residual hazards are reduced using any of the following
measures:
n
If relevant, there are safety fittings for the device. These devices are
essential for the safety of the device. Their functionality must be
ensured by carrying out the appropriate maintenance activities.
The safety fittings of the device are described in this "Safety" chapter.
n
If relevant, there are warning symbols on the device. These symbols must
always be observed.
The warning symbols on the device are described in this "Safety" chapter.
n
There are safety instructions in this operating manual. These instructions
must always be observed.
n
There are additional specific requirements for the staff and for the
personal protective equipment.
These requirements are described in this "Safety" chapter.
An overview of the authorised personnel and the protective equip-
ment can be found in
Ä
Chapter 1.12 “Personnel qualification”
on page 10 and
Ä
Chapter 1.13 “Personal protective equip-
ment” on page 10 .
Further information about the general structure of safety instruc-
tions can be found in
Ä
Chapter 1.15 “Structure of warnings”
on page 11 .
1.2 Observing additional operating instructions
Additional interface modules can be fitted to the device. Before installing
and using interface modules, always read and observe the operating manual
accompanying the relevant interface module.
Interface modules
V08 Variocool 7 / 97