Lauda Varioshake VS 60 OI, Руководство по эксплуатации

Страница: 8 / 26

8 / 26 Varioshake Shaking Incubator 09/2020
4 Transport, Assembly and Location of the Shaking Incubator
Provide suitable transport means to transport the unit to the location. Doors, lifts and hallways/ corridors to the location
must permit safe transport.
Caution:
the Shaking Incubator weighs 51 kg. Lift and carry the unit with at least two persons when transporting it
to the location.
Place only on firm, stable and level surfaces indoors. The location must offer sufficient space and must safely carry the
total weight of the unit (unit weight as per technical data, chapter 10 of these operating instructions, plus weight of the
load).
For safe handling of removed, warmed-up loads make sure to allow sufficient workspace in the direct vicinity of the unit.
The unit is not approved for operation in potentially explosive surroundings.
5 Operating Voltage
The Shaking Incubator must only be connected to a properly installed power connection with earth conductor (PE), ac-
cording to the local regulations. The Shaking Incubator is an electric appliance, protection class I, therefore, a connection
to earth conductor (PE) must be provided. The value of the required mains fuse is stated in the technical data, chapter 11
of these instructions. The electrical connection must be configured so as to secure that power can be cut all-pole at any
time.
It must be secured that, even after opening the cover, the mains connection cable does not touch any warm parts of the
interior or of removed, warmed-up load. The main switch on the control panel of the Incubator must be off
(position O). The operating voltage stated on the nameplate (on the back of the unit) must be identical to
the mains voltage. If they are identical, connect to the mains.
6 Inbetriebnahme
Caution:
due to high risk of injuries, never reach into the unit while the shaking device is still in operation.
Caution:
make sure that neither the shaking movement nor the heating process create an explosive atmosphere
near the Shaking Incubator during operation.
Caution:
hot surfaces in the interior when temperature is set to 50 °C or more. Danger of burns. Wearing suitable
safety gloves is recommended.