Lauda RP 3050 C, Руководство по эксплуатации

Страница: 84 / 136

Proline Kryomats
84
Starting up
YAUE0007 / 10/2/2018
Command

Control Parameters

Open the device parameter menu via the
soft key Menu .

With the cursor keys continue to:

Control

Control Parameters

Control Parameters .

The adjacent window appears.
Parameter endings:
e = Master controller, f = Slave controller.

Where applicable change parameters
marked with (auto) to manual input with
Tv manual/auto .

Select the parameters to be changed with
and confirm with .

Then change the value in the following
settings window and confirm with .

Correction limitation see introduction.
7.11.2.1 Steps for setting the control parameters for external control
1. Activate external control

7.5.4.
2. Setting the slave controller:
2.1. Set parameters to auto ; Check for thermostat type and change when necessary (RP....)

9.1.1.

Choose heat transfer liquid with low viscosity and high thermal capacity.
Ranking: water, ethanol, water-glycol, oil, Fluorinert®.

Set pump level as high as possible,

make bath circulation strong and fast,

choose hose length as short as possible, i.e. 2 x 1m,

choose hose cross section as large as possible, i.e. ½ inch,

throughput through the external load as large as possible.
2.2. Xpf setting:

when oscillating with short period occur (i.e. 30 seconds)

Xpf lower, otherwise higher,

in case of bad thermal coupling and large thermal mass

high (i.e. 2
– 5, or even higher),

in case of good thermal coupling and small thermal mass

low (i.e. 0.2
– 0.7),

when rapid temperature response is required simple internal control should be preferred.
Otherwise select small Xpf (0.05
– 0.1).
3. Setting the master controller (PIDT1-controller):

Start with setting Auto and proceed with Manual only when necessary.
Pump Menu End T
set
T
fix
Control Parameters
Control para. sets
Tv manual/auto
Self Adaption
Correction limitation
Kpe 0,50
Tne 100
Tve (auto) 83
Tde (auto)
8,3
Xpf 4,0
Prop_E(a) 30