Lauda ECO Silver E 4 S, Руководство по эксплуатации

Страница: 49 / 128

10/2019 i
ECO Silver 49 / 124
7.3.3 Entry window
Values are input using the entry window.
In the entry window the following information is displayed:
The first line contains the input parameter in short form (cf. example T
set
).
Min. and Max. state the limits for the value to be entered.
The value to be entered is shown in large characters. The cursor flashes
under the value.
You can change the value with the cursor key or . If you keep one of the
two cursor keys pressed longer, input is speeded up.
By pressing or you can also select numbers individually and change them
with or .
By pressing (+/-) the arithmetic sign can be changed.
The enter key takes over the set value.
By pressing (ESC) you are returned to the menu level without any
change.
7.4 Basic setup
In this section the settings required for using the device as prescribed are summarized. For more extensive settings refer
to the appendix (

Other settings).
7.4.1 Setting the overtemperature switch-off point T
max
Warning!
Overheating due to entering an incorrect T
max
and set-point tempera-
ture
Burns, scalds, fire
 Set T
max
in each case according to the heat transfer liquid
used. T
max
must be below the flash point.
–
Hold the key pressed during the complete setting procedure:
–
Press the enter key .
The entry window appears. The cursor flashes under the T
max
value. The
maximum and minimum adjustable temperature values are displayed.
–
Change the value with or .
Note: With a longer depression the figures increment faster.
–
Single figures can be selected by pressing or .
Tmax
Min: 0
Max: 152
ESC

OK - - -
85
Tset
Min: -30.00
Max: 152.00
ESC

OK + / -
85