MachXO2 Breakout Board Evaluation Kit
Evaluation Board User Guide
© 2014-202
2
Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
FPGA-EB-02051-2.3
11
6.3.
Programming a Demo Design with the Lattice Diamond Programmer
The demonstration design is pre-programmed into the MachXO2/MachXO3 board by Lattice. If you have changed the
design but now want to restore the board to factory settings, use the procedure described below.
To program the MachXO2 device:
1.
Install, license and run Lattice Diamond software. See
http://www.latticesemi.com/latticediamond
for download
and licensing information.
2.
Connect the USB cable to the host PC and the MachXO3 board.
3.
From Diamond, open the
Default_pattern_w_standby.ldf
project file.
4.
Click the
Programmer
icon.
5.
Click
Detect Cable
. The Programmer detects the cable (Cable: USB2, Port: FTUSB-0). If the cable is not detected,
see the
6.
Click the
Program
icon. When complete,
PASS
is displayed in the Status column.