Quick
START
CrossLink: LIF-MD6000
Master Link Board
Check Kit Contents
The CrossLink: LIF-MD6000 Master Link
Board includes the following items:
LIF-MD6000 Master Link Board
SMA I/O Link Board
Breakout I/O Link Board
USB cable for programming
12 V AC adapter power supply
Quick Start Guide
The CrossLink: LIF-MD6000 Master Link Board
is an evaluation and development platform for the
CrossLink (LIF-MD6000) device. The board also
features a MachXO3LF-1300E FPGA.
In addition to general-purpose resources, the board includes two Tx and two Rx
connectors on the edges of the board for building CrossLink video bridging solutions.
For more information on these and all board features, see the Lattice website at
www.latticesemi.com/masterlink.
To develop your own designs, you can use the Lattice Diamond software, available at
www.latticesemi.com/diamond.
To re-program the board, you will need Diamond Programmer version 3.7 or later.
Diamond programmer can be downloaded from the Lattice web site at
www.latticesemi.com/programmer.
Note: SW1 is the master power switch. Switch is ON when moved toward the edge of
the board.
Check Jumper Settings
This document provides a brief introduction and overview of the CrossLink: LIF-MD6000
Master Link Board, Rev C.
1
2
JUMPER
DESCRIPTION
DEFAULT
SETTINGS
J7
SW2 selector
SHORT 1-2
J16
SPI/I
2
C programming
selector for
LIF-MD6000
SHORT 1-2
(SPI)
J19
SPI Flash chip select SHORT 1-2
J24
VCCIO1 Bank
voltage selector
SHORT 2-3
(3.3 V)
J25
VCCIO2 Bank
voltage selector
SHORT 2-3
(3.3 V)
J26
Internal/External clock
and I
2
C SDA Mux
OPEN
JUMPER
DESCRIPTION
DEFAULT
SETTINGS
J27
Internal/External
reference clock and I
2
C
SCL Mux
OPEN
J29
Reset signal voltage
selector
OPEN
J35
SPI/I
2
C programming
selector for LIF-MD6000
SHORT
1-2 (SPI)
J36
SPI/I
2
C programming
selector for
MachXO3LF-1300E
SHORT
1-2 (SPI)
J37
FT2232H reset
OPEN
