Lastec 325EFR-H, Руководство пользователя

Страница: 29 / 32

Maintenance
Every 8 Operating Hours
Maintenance 325EFRH/Odoc100499 5-1
5
SECTION 5 Maintenance
Along with completing the Pre-Operation Equipment Inspection Checklist each time
you operate the Articulator, complete the following Maintenance Checklists at the indi-
cated time intervals.
5.1 Every 8 Operating Hours
l
Complete the Pre-Operation Equipment Inspection Checklist.
l
Grease all grease zerks.
l
Grease the PTO shaft collar and both cross bearings.
l
Inspect the spindle bearing grease seals (under each deck) for grease leakage or
improper seating.
l
Lubricate all joints and moving parts which are not equipped with grease fittings.
Motorcycle oil or WD-40 is recommended for these areas.
l
Verify proper installation, operation, and flow of grass chute.
l
Inspect entire Articulator for loose or entangled parts, debris, obstructions,
neglected tools, or any other possible safety hazards, equipment hazards or projec-
tile hazards.
l
Perform the appropriate maintenance procedures listed in your tractor manual.
5.2 Every 25 Operating Hours
l
Complete the 8 Hour Maintenance Checklist.
l
Grease all wheel hubs.
l
Lubricate the PTO quick-disconnect pin or twist sleeve.
Proper maintenance of the Articulator is important!
ALWAYS perform the appropriate Maintenance checklist at the proper
time interval!
Failure to complete the appropriate Maintenance checklists at the
proper time intervals will cause damage to the Articulator, unsafe
operating conditions, and substandard performance!
Warranty issues are dependent upon proper maintenance!
Go to www.lastec.com for latest changes in this manual.