3.7 - Choosing and Installing the Pattern Bar
3.7.1
Your FM-2.1 comes with five pattern bars included: four (4) com
-
mon patterns and one blank pattern as shown in diagram 3-100.
Choose the pattern bar that lines up with your desired pattern.
Diagram 3-100
Blank (Customizable)
3 holes 2-3/4” apart center to center
3 holes 3-1/2” apart center to center
2 holes 2-3/4” apart center to center
3 holes 4-1/4” apart center to center
(standard three ring binder)
3.7.2
Insert a Pattern Bar by loosening the Pattern Bar Stop (EZ-1022)
and inserting the desired pattern into the slot on the Pattern Bar
Guide as shown in diagram 3-50. Insert the angled end into the
slot as far as it will go so that the slot at the end of the Pattern Bar
lines up with the Pattern Bar Stop. When you have the pattern
correctly inserted, tighten down the Pattern Bar Stop through the
slot on the Pattern Bar locking it in place.
Diagram 3-50
3 - Setting Up Your Machine
3.8 - Electrical Instructions
3.8.1
3.8.2
Your FM-2 comes with an electrical cord containing the plug to
fit into a standard grounded 115V outlet. This machine has a full
load draw of 5 Amps.
Making sure that nothing is interfering with the drill bits, plug the
cord set into a grounded 115V outlet. To turn the machine on,
press the Rocker Switch on the front of the shroud.
Diagram 3-60
Rocker Switch
Power Cord
Page 08
