Laserscale SET-HD100, Инструкция по эксплуатации

Страница: 48 / 74

SET-HD100
4
(E)
2-3. Interpolator Unit
2-3-1. Front Panel
1 USB connector
2 Status indicators
3 Monitor connector
(MONITOR)
4 Head unit input connector
(ENCODER IN)
5 SELF CAL switch
a USB connector
Th e interpolator unit self-calibrates the sensor signals output by the head unit and calculates the
angular data in real time. Th e angular data is then output to a computer from this connector in the
specifi ed format.
Connect to the computer using a USB cable (USB 2.0 Type B). (Th e customer should procure the USB
cable separately.)
b Status indicators
Th ese indicate the status of the interpolator unit and the input data.
Indicator Color Status
POWER Off Power supply off
Lights up green Power supply normal
STATUS Lights up green Normal
Lights up or blinks red Error
CONFIG Lights up green Startup normal
MODE Off Power supply off , before reference point detection
Lights up green Measurement mode (normal operation)
Blinks up green Calibration mode
Lights up orange Reference point detected, applying compensation value
SENSOR 1 to 6 Lights up green Sensor normal
Lights up red Level alarm : Sensor signal level low
Speed alarm : Sensor speed exceeded
(Real-time display)
All the LEDs light up orange for several seconds after the power is turned on.
c Monitor connector (MONITOR)
Th is is a dedicated connector for service work.
d Head unit input connector (ENCODER IN)
Th is inputs the sensor signals output by the head unit.
Connect the supplied connection cable.
Note
Be sure to always turn off the power before connecting or disconnecting the connection cable. If the
cable is connected or disconnected while the power is on, the sensor light source may be damaged.
e SELF CAL switch
Open the transparent cover and press this switch to start self-calibration.