Laserscale BL57-RE, Инструкция по эксплуатации

Страница: 35 / 108

BL57-RE
(E)
4-7
ON OFF
ON OFF
4-5-5. Setting the Reference Point Output and Reference Point Detection
Direction
The MODE switch 7 (Reference point output selector switch) is used to set the reference point output to
output in a single direction or output in both directions. When set to single direction (ON), the reference
point detection direction can be set.
If MODE switch 7 (Reference point output selector switch) is set to both directions (OFF), MODE switch 4
(Default reference point detection direction setting switch) and MODE switch 9 (Reference point detection
direction selector switch) are disabled.
1
Make the setting for MODE switch 7.
ON ......... Outputs the reference point signal in a single direction
OFF ....... Outputs reference point signal in both directions (However, the reference point position is
shifted by approximately 4 mm when detecting in the opposite direction from the default
reference point detection direction.)
If the switch is set to OFF, the procedure is completed.
Perform the procedure starting from step 2 only if the switch is set to ON.
2
Use MODE switch 4 to set the default reference point detection direction.
ON ......... Default reference point detection is in the reverse direction
OFF ....... Default reference point detection is in the forward direction
3
Use MODE switch 9 to set the reference point detection direction.
In this case, the reference point detection position is not shifted even if the detection direction is opposite
the default reference point detection direction.