LaserLine LA251, Руководство пользователя

Страница: 23 / 32

LEARNING OF THE NEW TRANSPONDER AND THE ULTRASONIC MODULE
Learning a desired transponder at a time (a maximum of 90); need to do:
3) Within 30 seconds of double beep of the confirm of the entry in the learning procedure, press and
hold the transponder button that you want learn for about 3 seconds until the It’s LED will emit two
quick flashes then release immediately the button.
As confirmation the siren will emit a short beep.
NOTE:
The learning of a transponder must be done within 30 seconds from the beep of confirm of the last
transponder learning, otherwise the procedure will be finished.
4) Within 30 seconds from the last transponder learning is necessary learn the ultrasonic module by
opening the vehicle door and entering into the vehicle.
The confirmation of the correct learning will be signalled by a short beep of the siren followed by a
long beep that will indicate the end of the learning procedure
EXIT FROM THE LEARNING PROCEDURE
The exit from the learning procedure occurs automatically after the learning of the Ultrasonic Module
(long beep of te siren as confirmation).
Where the Ultrasonic Module is not present, to exit from the procedure is necessary wait 30 seconds
after the last transponder learning.
The exit from the learning procedure will be signalled by a long beep of the siren.
NOTES:
If, during the 30 seconds of the learning procedure, is not learned anyone transponder, the alarm
automatically exits from the learning procedure (long beep of the siren as conf rmation), leaving i
unchanged the transponders and the ultrasonic module previously learned.
If instead is learned at least a transponder, all those previo sly learned will be deleted, also the u
Ultrasonic Module, if present.
Accordingly, the tran ponder used for entry into learning procedure (see chapter 2) must be learned
s
again (see chapter 3) if you want to continue to operate after the learning procedure. It
The maximum number of transponders that can are learned is 90 units.
If the bonnet contact is not connected during the installation, the grey wire used for the learning
procedure must be taped and left floating at the end of this procedure.
X2
At the double LED
flashing release the
button
3”
1 beep of the siren
X1
1 short beep of
the siren
X1
1 long beep of
the siren
X1
EXIT
Open the vehicle
door
Learn a next
transponder
(see chapter 3)
OR
Learn a U.S.
Module
(see chapter 4)
Keep press for 3”
PAG. 23