ENGLISH
14
FUNCTION ACTIVATED IMMEDIATELY AFTER ARMING
SELF POWER:
Any attempt to cut the power wires will cause the alarm (989-975 only).
IGNITION KEY:
Any attempt to start the car will cause the alarm.
IMPORTANT :
self powered siren (989-975 only) are fitted with an automatic system for
internal battery power supply. Full charge of the internal siren happens during first
15 hours
of the operation. Furtherly, the battery power charge is automatically controlled and
mantained.
FUNCTIONS ACTIVATED 40" AFTER ARMING (PRE-ALARM TIME)
When the alarm is armed remote (during the first 40"),
SHOCK SENSOR/BOOT/BONNET/
DOORS/ULTRASONICS
detection is signalled by three LED flashes and three acoustic signals.
After the pre-alarm time the sensors will cause an alarm condition.
SHOCK SENSOR:
Appropriate impact to the vehicle will cause an alarm condition.
BOOT/BONNET/DOORS BUTTONS:
Opening of protected areas will cause an alarm
condition.
ULTRASONICS
: Appropriate movement inside the vehicle will cause an alarm condition.
DROP IN VOLTAGE
(bulb lighting): instantaneous alarm
In alarm condition the piezo-electronic siren sounds and the direction lights flash for 30 seconds.
When the alarm is disarmed NO function is activated.
When ignition key is ON it is not possible to arm the alarm.
If there are three consecutive alarm conditions caused by the same detector (ULTRA-
SONICS SENSOR/PUSH BUTTONS), after the third cicle of siren sound, that detector
is excluded but it is not possible to start car engine.
SECURITY KEY:
in OFF position it excludes all the alarm functions and restores the connection
of the engine immobilisation circuit. This ensures the vehicle may be driven until any fault is
rectified.
SELF DIAGNOSTIC LED FUNCTIONS
This function lets you verify the cause of an alarm condition. When the alarm is disarmed by
radio control, observing the LED will allow you to identify the cause of the alarm condition.
LED OFF:
no alarm occured
1 FLASH/PAUSE:
an alarm caused by a VOLTAGE DROP has occured
2 FLASHES/PAUSE:
an alarm caused by ULTRASONIC has occured
3 FLASHES/PAUSE:
an alarm caused by INSTANTANEOUS push button bonnet, boot has occured
4 FLASHES/PAUSE:
an alarm caused by SHOCK sensor has occured
5 FLASHES/PAUSE:
an alarm caused by IGNITION KEY sensor has occured
6 FLASHES/PAUSE:
an alarm casued by CUTTING SUPPLY WIRES has occured
Turning the ignition key on or re-arming the alarm system by remote will re-set the diagnostic
memory.
SPECIAL FUNCTIONS
PANIC:
Pressing the upper button will activate the siren for 10 seconds. If you wish to stop
it during this time push it again.
CASUAL RE-ARMING:
If the alarm is casually disarmed it will re-arm itself if the driver
side door is not opened within 40" from alarm disarming .
This function can be excluded to set the dip-switch n°4 in ON position (see dip switch coding table)
!
ATTENTION
is 989E ita-ing.pm6
05/03/98, 16.42
14
